Slick 60's

Somewhere in the Ozarks......

Still a huge amount of good parts there

Don't tell me all that is headed to the crusher

This guy keeps all his old stuff,all the imports get crushed.......going back in the morning for a set of nice fenders and a couple of 16",8hole lock ring wheels for Farmmotorsports.....

Dan , keep an eye out for a 6 bolt rim for a f350
Be nice to find one for a single wheel truck
But I can run one built for a dually

I have a couple that can not be run on rear because of the off set,might be front only 6 hole 16” look jus just like a Dually with the six slots

what size you need? I may still have some 17s that came on my truck.

7.50-17 is what I have on

I'm wanting to keep it the same if possible
I have a 16" that will work , but the offset is different
I can run it in the back axle , but not front

I'd like to have one that is the same
Your 17" sounds like it might be

will check this weekend and see if I still have them.


Dan the next time you go to your honey hole see if you can find a good front bed panel for a wrongbed
64x19 and how much. I could probably be persuaded to come out there for a good 9ft wrongbed.

Pat. PM sent

Mr. Jones wrote:This guy keeps all his old stuff,all the imports get crushed.......going back in the morning for a set of nice fenders and a couple of 16",8hole lock ring wheels for Farmmotorsports.....

I live 45 minutes from Springfield, mo where is this exactly? My 64 needs a drivers fender, door panel trim and mechanical door odd and ends.