Thank you from New York

chilly803 · Post by **chilly803** » December 21, 2012, 3:29 pm

From upstate New York I would like to say what a wonderful site with a bunch load of information. I'm building a father son 66 F100 project with my son and with access to your site we have installed a 460 engine in it as well as power steering from a 79 F100 from all the information found on your site. Was just accepted to your site, with that being said, again thank you, I had just ordered new cab bushings for the cab and core support as we are having trouble trying to get the firewall plate that holds steering column to line up in bolt holes and to strap column firmly to firewall, the column is from a 72 F150 cant remember if it had power steering or not. Maybe when bushings get here that will solve problem and we can keep building. Thanks to a wonderful site and to some GREAT knowledge out there.

ThinLizzy13 · Post by **ThinLizzy13** » December 21, 2012, 4:10 pm

from upstate New York as well

Post by **foodstick** » December 21, 2012, 7:25 pm

Iowa says HI ! welcome aboard...

ICEMAN6166 · Post by **ICEMAN6166** » December 21, 2012, 7:52 pm

welcome from SE Utah

slick4x4 · Post by **slick4x4** » December 21, 2012, 8:07 pm

F. R. O. M.

K A N S A S

F7BIGJOB · Post by **F7BIGJOB** » December 21, 2012, 8:43 pm

From Ro Diland

ras4434 · Post by **ras4434** » December 21, 2012, 9:45 pm

Welcome to the Brotherhood of the Addicted.....(Addicted to the trucks that is) from Oregon. Always room for one more...............

William-in-St George · December 22, 2012, 11:55 am

Ditto from the northern end of the Mohave. To fit the column, be sure the cab is lined up, remove the dash clamp, install the flexible joint, firewall plate and boot (loosely), then re-install the dash clamp and tighten all the bolts. Check for binding. You can shim the steering gear box between the frame and box but usually this is not necessary. Sawsall gets the old bushings out in short order. Don't over tighten the new bolts. Drain the fuel tank before you move it too get to the top end of the rear cab mount bolts.

kevin steidle · Post by **kevin steidle** » December 22, 2012, 12:55 pm

From up state New york in coblesskill

kstones63 · Post by **kstones63** » December 23, 2012, 11:05 pm

Welcome from Phoenix.

Kevin

Hunter's 64 · Post by **Hunter's 64** » December 24, 2012, 2:32 pm

From Sunny Florida

Doing a Father / Son project also.
Danny

Thank you from New York

Thank you from New York

Re: Thank you from New York

Re: Thank you from New York

Re: Thank you from New York

Re: Thank you from New York

Re: Thank you from New York

Re: Thank you from New York

Re: Thank you from New York

Re: Thank you from New York

Re: Thank you from New York

Re: Thank you from New York