Removing "Twin I Beam" emblem tricks?

OldDawg · Post by **OldDawg** » November 29, 2011, 1:53 pm

Hey guys, I want to pull these off to clean behind them and install new red "Twin I Beam" stickers on the inside. I looked at the little clips that are holding them on and couldn't figure out how to get them off. Any of you have experience with these?

thanks,

OldDawg

66 F100

(alt+p)[/img]

Bill W · Post by **Bill W** » November 29, 2011, 2:00 pm

take a plastic putty knife and work it between the emblem and the fender... they just press on and off with 3 pins, one pin at the bottom and 2 at the top.

also Welcome to Slick 60's!

OldDawg · Post by **OldDawg** » November 29, 2011, 3:36 pm

Thanks Bill, I'll give it a try!

~OldDawg

Gritsngumbo · Post by **Gritsngumbo** » November 29, 2011, 4:03 pm

from Louisiana!
How about pictures of the rest of your truck

?

OldDawg · Post by **OldDawg** » November 29, 2011, 6:16 pm

Hey Grits,

I have a bunch of photos for the truck ready to go, it's just not something I can upload from work unfortunately. I'll get them up on Flickr as soon as I can and put a bunch here.

thanks for asking!

~OldDawg

Gritsngumbo · Post by **Gritsngumbo** » November 29, 2011, 6:23 pm

Just messin' with you a little. We DO like pictures, though.

Anthony · Post by **Anthony** » November 29, 2011, 9:02 pm

Welcome to the Slickness from West Virginia!!!! Hang around and you'll find a bunch of guys and gals on here that know "ALL" the neat little tricks...

OldDawg · Post by **OldDawg** » November 30, 2011, 12:39 am

Hey guys, Bill, thanks again for the tip, it worked! They came off very easy.

Here's a link to my Flickr album on Shep.

http://www.flickr.com/photos/ajporsche/ ... il/?page=2

Thanks again, see ya on the road!

~OldDawg