I hope so I got my bags so i can start on mounting them in the truck.

Thanks man!!! Laid out it is on the rockers and it does not turn lol but when I get the bags on I should be able to raise it around 10 in. or so with no issues.

It's a little scary cutting into one but I believe it is going to turn out to be a nice truck thanks for the positive comments. I will post more when I'm not working my real job.

I have 4.25" from the frame rail to the tire and 2" from the shock mount to the tire.

I will have to run a 45mm-50mm offset wheel I don't think width will be an issue but the CV track width is wide. I will measure it when I get home today and post it. I kind of like the steel wheels I'm thinking about getting them powder coated an off white with a red pin stripe. I think I could run ...

What are you putting on the cv frame I am in the process of doing a 65 f100 on a 03 CVPI chassis and I ended up body dropping it about 4" using the cv floors and firewall and it lays on the rockers

Here she is layer out no rear springs no front struts low and wicked as hell looking I have got to cut the drive shaft tunnel to get the rear of the cab down but it only needs about 1/2 in so not to bad. http://imageshack.com/a/img834/6697/gksy.jpg http://imageshack.com/a/img834/4154/otzv.jpg http:/...

I put the cab back on and it cleared the CV pan and firewall extremely well I have to modify it of course but it's going to work out great! http://imageshack.com/a/img198/3396/c4nk.jpg http://imageshack.com/a/img707/8618/zgj1.jpg http://imageshack.com/a/img841/6775/zx6q.jpg Pretty much all the bed f...

Well I got another change of plan I have always wanted to build a bagged and bodied truck so back out comes the saws all and more cutting. I took the cab and bed off the chassis and bolted the CV floor and firewall to the factory CV body mounts. http://imageshack.com/a/img541/4923/49es.jpg I put the...

I channeled the cab 6 inches I'm hoping to lay the rockers!!!!! http://imageshack.com/a/img845/7830/kojv.jpg http://imageshack.com/a/img18/6610/nqaw.jpg http://imageshack.com/a/img41/2180/cxor.jpg http://imageshack.com/a/img30/450/9sle.jpg The Saleen wheels in the rear are to wide and I head to go w...

Cut the front pans out damn they were rust free

Ok so I know it looks a little goofy right now but I got to do a little nip tuck on her but I believe it will fit

I got the 65 sheet metal off today not very hard to do.

I finished drilling the firewall and removed the floor and firewall from the frame now I'm going to set the 65 in place and see where I need to start cutting.

The wiring harness looks intimidating as hell but I'm up for it.

Sawzalls are awesome now own to drilling out spot welds around the firewall. I plan on using the a/c and the brake booster. We shall see.

I decided to cut the cv in half on I used a cherry picker to remove the back half of it

Tear down lol

Put the rear end in the car drove it around runs and drives good!!

Found a PI rear end 3:27